Praga S5T-3 short flatbed

Paper model of the Praga S5T-3 flatbed truck. You can create the model with the interior of the driver's cab and the folding front hood. Of course, there is a detailed processing of all units (engine, chassis, cabin interior).

The scale is standard 1:32. The model is printed by offset on paper weighing 160g / m2, on a total of 4 pages B4. The manual contains a total of 19 three-dimensional instructional drawings and 5 "feathers" - details.

The model also includes a sheet of transparent foil for "glazing" the model.

Size: 205mm (length), 75mm (width), 75mm (height)

You can find all the parameters for the model on the side tab. We provide maximum information for each model so that you can make the right decision about your purchase.

We also offer laser accessories for the paper model. These are laser patterns, risers and a front mask that will raise your model to a higher level and simplify your work. You can learn more details about laser designs in the attached video.

The Praga S5T (road five-tonne, spoken-tipped) is a medium-tonnage road truck, built on the basis of the Praga V3S off-road three-tonne, from which it took over mainly the drive train, modified frame and cab. Unlike the V3S, the S5T is a two-axle, with rear-wheel drive (4 × 2 sign). Gradually, three development versions were created, differing mainly in the engine used. The basic design of the vehicle was a flatbed and a three-way tipper. In addition to them, however, other purpose-built superstructures were also mounted on the car. There were also variants with an extended wheelbase or an extended cab. Under the name S5T-TN, semi-trailer tractors were created based on a modified S5T chassis. The production of the Praga S5T car took place in the years 1956–1961 in AZKG Prague-Vysočany, and then, until its completion in 1972, in Avia Letňany.